Bully Dog Torque Dog Module

The Torque Dog Module also lowers EGT (exhaust gas temperature), decreases downshifting and increases fuel economy. Installs in minutes by plugging directly into the data port or stock connectors, depending on your specific Dodge. And, the Torque Dog is fully compatible with the Bully Dog Power Pup programmer and Outlook Monitor.

Increased Performance
Bully Dog’s innovative plug-in module is programmed to switch between stock, 35 hp and 65 hp. It adds up to 160 lbs.-ft. of torque. This module is easy to install and provides safe horsepower increases that will not compromise everyday driving.

Fully Adjustable On-The-Fly
The adjustable Torque Dog Plus Performance Module offers three horsepower/torque settings: Stock, Tow (50 hp and 105 lbs.-ft.), or Performance (90 hp and 190 lbs.-ft.) for proven maximum gain, on the 03-04.5 Dodge Cummins.

Easy Installation
The Adjustable Torque Dog is simple to install with most installs taking about 20-30 minutes.

Compatible
Works with Bully Dog Power Pup Downloader and OutLook Monitor on 03-05 Dodge.

• The Bully Dog Torque Dog Module is custom designed for your specific engine
• The Torque Dog boasts three pre-programmed settings that are adjustable on the fly
• Bully Dog’s Torque Dog delivers an extra 30-90 horsepower and 100-200 lbs of torque, depending on your specific Dodge engine
• Experience better fuel economy, lower EGT and few downshifts
• Straightforward installation lets you plug the Torque Dog Module straight into the data port or stock connectors
• Your Bully Dog Torque Dog Module is backed by a 1-year warranty and free 800-number technical support line service

No tools were required for the installation. We used a bottle of 409 cleaner and a clean rag to wipe off the Baja dirt from the mounting area.

Step # 1 - The injector pump connector is located on the driver's side of the Cummins power plant and is easily identifiable by matching up the female cable connector with the same style connector at the injector pump.

Step # 2 - Once you identified the injector pump and the female cable connector, remove the pump connector by sliding the connector clip. We discovered that it doesn't slide very easily, of course, it was covered with dirt and dust from the roads and beaches of Baja, but with a little coaxing, it slid right out.

Step # 3 - Identify the male and female ends on the Torque Dog.

Step # 4 - Connect the Torque Dog male cable connector to the factory harness end.

Step # 5 - Make sure that the interlock connector is open completely.

Step # 6 - Connect the Torque Dog female cable connector to the Diesel Injection Pump.

Step # 7 - Make sure that the interlock connector closes completely.

Step # 8 - Route the Torque Dog and wiring loom from the Injector Pump to the top of the fuse box, located against the driver's side front quarter panel, and that will be it's new home. We cleaned off the top of the fuse box and then wiped it down with the alcohol pad provided by Bully Dog, allowing the alcohol to dissipate.

Step # 9 - Peel of the Velcro protective film and firmly place the Torque Dog in place.